3D Printable Deburring Tool Handle

Download STL Files (zip) Download Fusion 360 Archive

Originally published on Thingiverse

Summary

To use, insert a 0.125” shank deburring blade into the end of the handle until the groove in the blade lines up with the hole in the side of the handle. Press the clip into the hole until it snaps into place around the blade. Reverse this process to remove the blade.

Depending on your printer and the material you use for the clip, the blade will probably not spin freely but will rotate well enough for normal use (deburring holes). Friction can be reduced by enlarging the center hole on the clip or adding some grease in that area.

Printing

Print on its flat side in any material, at up to 0.3mm layer height. Depending on how well your printer is tuned, you may or may not need supports to print the hole properly. If you use supports, you will probably need to drill out the hole to remove them.

License

This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.